Biophysical lab report

Since two microhabitats were on the ground, with more coverage, and had a higher temperature than the two other microhabitats that were more exposed to conditions and were higher in elevation, the group concluded that if an ectotherm is higher in elevation and exposed to conditions such as wind the body temperature of that organism will be lower than an ectotherm on the ground.

The groups started by making a column in each of the two charts for time elapsed, then the temperatures for each minute recorded from the I-buttons Biophysical lab report put Biophysical lab report the next five columns Biology Handout, Graphing Populus Data pg A group member held the thermometer very close to the microhabitat and pressed the button on top for five different temperature readings in degrees Celsiusthese temperatures were recorded.

Then a new chart was created in Excel below the previous two, but on the same page by copying and pasting the time elapsed column, then the confidence intervals, averages, and upper and lower confidence intervals for both microhabitats.

The small I-buttons were taken out of ice water and pressed into a hole that was made with then end of a pen cap into the bottom of the marshmallow Peeps. For future experiments in this subject it would be more beneficial to test microhabitats that vary more in temperature to truly be able to analyze the factors of thermoregulation in microhabitats.

The temperature differences of the two microhabitats were taken by using infrared thermometers. The upper confidence intervals were calculated and put in column ten.

A group member calculated the upper confidence interval in each chart by, finding the average from the row of the same minute for the microhabitat and adding it to the confidence interval, and repeated for every minute elapsed in both charts. Then a line graph was generated in Excel to display the data from the I-buttons Figure 5.

The microhabitats were found by analyzing the temperature differences within the habitat. Then, dragged the blue marker in the corner of the box down the column to find all of the confidence intervals Biology Handout, Graphing Populus Data pg After gathering the temperatures from the I-buttons, over a twenty minute reading in each microhabitat the data was organized in Excel?

The habitat under the oak tree was used to analyze the microhabitats within it, one at the ground of the tree and one on a branch of the tree, six feet above the ground. The lower confidence interval was then calculated and put in column eleven of each of the two charts.

Through analyzing the microhabitats of Maxcy Gregg Park it was predicted that the elevation, related to wind availability and convection, is a pattern that could affect ectothermal organisms by decreasing the body temperature of the ectotherm as the organism increases in elevation.

Then, dragged the blue marker in the corner of the box down the column to find all of the standard deviations Biology Handout, Graphing Populus Data pg The habitats chosen in this lab were under a large oak tree and in a shaded area in the front of the park. The group used ten I-buttons, temperature-recording devices, and ten marshmallow Peeps to analyze the temperatures of ectothermal organisms within microhabitats.

First, two charts Figures 1 and 2 were made, one for temperatures from microhabitat one and the next for microhabitat two labeled Branch and Ground.

The groups then analyzed the recordings of the infrared temperatures within the four microhabitats. Then the average of each of the five I-button readings were put into the seven column of each of the two charts.

After arriving at Maxcy Gregg Park and analyzing the temperatures of four microhabitats within two habitats with infrared thermometers, the temperatures were compared between the microhabitats.

This was repeated for each minute elapsed. Twenty minutes later the stop time was recorded and the group took the I-buttons out of the Peeps, recorded the serial numbers of the I-buttons corresponding to the microhabitat they were placed in and then returned the materials to the lab TA and the Peeps were discarded.The BPP is safe and non-invasive.

It lasts about 30 minutes. Part of the biophysical profile is an ultrasound. This tracks your baby's movement and tests the amount of amniotic fluid. You'll lie. Biophysical Lab Report; Biophysical Lab Report. 7 July Science; There are many patterns that can be observed throughout our environment.

In this experiment, the temperatures of organisms in a biophysical environment were analyzed to see if a pattern could be recognized that was related to the behavior of an ectotherm.

An ectotherm is an.

Biophysical Profile (BPP)

CHML: Biophysical Laboratory for UF Chemistry Majors Sections 7F03 (T), (W) Full Report (1) 15% Total % Due Dates are given or are relative to the day of your lab session.

Report Details will be given in the course website. Prelab Quizzes. In any rotation, you are to perform the pre-lab quiz individually for the experiment.

Biophysical Lab Report

Unformatted text preview: Brad Trent BIOL L – 18 February Biophysical Ecology Lab Report Effects of Conduction on Ectotherms in a Measured Habitat Introduction Heat transfer between and organism and its environment is a very important and common study of biophysical mint-body.coment organisms can use a wide range of heat transfer methods that allow for it to survive and thrive.

Instructions for the final laboratory report Your Full Name Cebu Institute of Technology - University [email protected] Abstract The abstract should have a maximum of words and should briefly state the problem, method, and the summary of the lab reports can be computerized or handwritten with 2 cm (1 in) left and right indention for the abstract.

I am equally proud to be working with the Biophysical Society of China, and Biophysics Reports is the society’s official journal. With Biophysics Reports, we will provide a resource on novel theories, methods, protocols and improvements on basic research techniques in the biological and biomedical sciences.

Biophysical lab report
Rated 3/5 based on 11 review